Mask,high-fil,FFP2/N95/KN95,no valve

General Description:
Non-fluid resistant respirator mask protecting against airborne pathogens. Anti-penetration high filtration mask

Intended use:
To reduce the healthcare workers risk of inhaling hazardous airborne particles (including dust particles and infectious agents), gases, or vapors. Worn on the face and covers at least the nose and mouth.

Technical specifications
Material: non-woven filter layer
Filtration level: > 95 % for particles from 0.1 to 0.3 micron
Air permeability: > 2 mm H2O
Shape of the mask: duckbill, folded (horizontal) width-wise
Without valve
Respirator mask fits all face shapes, without inspiration/expiration air-leakage
Upper edge has integrated easy malleable nose bridge strip reducing fogging of protective eye-wear
Size nose bridge strip: 4 x 90 mm (w x l) (+/-10%)
Two pre-attached elasticated straps, fitting (i) around top of the head ,(ii) around base of the head
Colour: white or green
Non-sterile
Single use, disposable
Each mask bares clear identification of
(i) protection provided FFP2/N95/KN95
(ii) which side to wear up (nose),
(iii) manufacturer's name, and
(iv) model reference

Respirator mask conforms to standards:
NIOSH N95 recommended by the CDC and WHO for healthcare workers. The disposable respirator should be marked with the manufacturer's name, the part number (P/N), the protection provided by the filter (e.g. N-95),and "NIOSH."
Or
EN 149: 2001/FFP2 recommended by WHO for healthcare workers. The disposable respirator should be marked with the manufacturer's name, EN 149: 2001/FFP2 and CE certification number. Must comply with PPE Regulation (EU) 2016/425 - category III.
Or
GB 2626, minimum KN95 recommended by WHO for healthcare workers. The disposable respirator should be marked with the manufacturer's name, GB 2626/KN95 and product reference.
Or alternative equivalent set of standard

Supplied with:
Supplier's instruction for use

Shelf life:
As indicated by supplier

Storage conditions:
As indicated by supplier

Packaging and labelling:
Primary packaging: Unit of use
One (1) piece

Labelling of the primary packaging displays, at least: product name ,product reference, manufacturer name, size, type and performance testing information against the mentioned standards. Information for particular storage conditions (temperature, pressure, light, humidity, etc.), asappropriate (or equivalent harmonised symbol), if applicable. Allindicated at least in English